Connect 56k Modem to Aux port of Cisco 2511

[namesrhard2pick]

I need some help connecting a 56k modem to the aux port of my 2511 access server. I would like to access my lab remotely via dial up.

This is what I have
US Robotics 56k (v.92) modem
Black satin roll over cable
DB25 to RJ45 modem connector (correct pin out)

Below is my show line

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 0 0/0 -
1 TTY 9600/9600 - - - - - 0 0 0/0 -
2 TTY 9600/9600 - - - - - 0 0 0/0 -
3 TTY 9600/9600 - - - - - 0 0 0/0 -
4 TTY 9600/9600 - - - - - 0 0 0/0 -
5 TTY 9600/9600 - - - - - 0 0 0/0 -
6 TTY 9600/9600 - - - - - 0 0 0/0 -
7 TTY 9600/9600 - - - - - 0 0 0/0 -
8 TTY 9600/9600 - - - - - 0 0 0/0 -
9 TTY 9600/9600 - - - - - 0 0 0/0 -
10 TTY 9600/9600 - - - - - 0 0 0/0 -
11 TTY 9600/9600 - - - - - 0 0 0/0 -
12 TTY 9600/9600 - - - - - 0 0 0/0 -
13 TTY 9600/9600 - - - - - 0 0 0/0 -
14 TTY 9600/9600 - - - - - 0 0 0/0 -
15 TTY 9600/9600 - - - - - 0 0 0/0 -
16 TTY 9600/9600 - - - - - 0 0 0/0 -
17 AUX 9600/9600 - inout - - - 0 1 0/0 -
18 VTY - - - - - 0 0 0/0 -
19 VTY - - - - - 0 0 0/0 -
20 VTY - - - - - 0 0 0/0 -
21 VTY - - - - - 0 0 0/0 -


I configured my line aux 0 with the following: Am I configuring the correct line based on my show line?

line aux 0
password xxxx
login
modem InOut
transport input all
flowcontrol hardware
stopbits 2

When I dial in I get a blank screen. I did the reverse telnet to my loopback address of 100.1.1.1 2001 and get the login prompt. I entered my password and got the ok...still no luck.

Thanks.

 

[North323]

what are you dip switches set at on the modem? have you tried to google the answer? i know it relies on those dip switches being correct

 

[namesrhard2pick]

Dip switches are 3 and 8 down, all others up.

 

[whykap]

here you go. Follow this doc and it will work.

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a00800941c9.shtml