Configuring Two Separate DHCP Pools

[garcia79]

I have one router configured as a DHCP Server and I am trying dynamically assign addresses to two other routers. I configured two dhcp pools, 1 for each routers' network. One router has the address 10.101.10.* and the other has the address 10.100.10.* (on their E0) however, the router acting as a DHCP server is assigning both DHCP clients with addresses from the 10.101.10.0 network. Is it possible to configure the DHCP server to assign a different pool of addresses for each network and if so how may I go about doing this?
This is how my config.s for dhcp look at present:

no ip dhcp conflict logging
ip dhcp excluded-address 10.101.10.0 10.101.10.15
ip dhcp excluded-address 10.100.10.0 10.100.10.15
!
ip dhcp pool dpool
network 10.101.10.0 255.255.255.0
default-router 10.101.10.1
!
ip dhcp pool cpool
network 10.100.10.0 255.255.255.0
default-router 10.100.10.1

Thanks in advance

 

[Whoheard]

Try this page and see if it can help.

http://www.cisco.com/en/US/products...er_guide_chapter09186a00800a5bdb.html#xtocid3

bob