Hi,
How can I setup a component I have installed on NT4 to run
as a specified user and not the interactive or logged on user?
On Windows 2000 I can use the Component Services Consule to change the identity to a user I specify but I don't see a way of doing this under Windows NT4. Also I am using the Microsoft scripting controls and would like these to also
run as a specific user.
Any help here is appreciated.
Stuart
How can I setup a component I have installed on NT4 to run
as a specified user and not the interactive or logged on user?
On Windows 2000 I can use the Component Services Consule to change the identity to a user I specify but I don't see a way of doing this under Windows NT4. Also I am using the Microsoft scripting controls and would like these to also
run as a specific user.
Any help here is appreciated.
Stuart
