shownuff001
IS-IT--Management
What steps does one take to console into a router using minicom.
I currently have it set to use
96008n1
serial /dev/ttyS0
but when I execute this it wants to initialize modem
??? what gives I never had this happen before?
any tips
when i hyperterminal to the router through Hyperterminal
it goes through regular boot up and extracts image and goes through interfaces serial interac s0 s1 are administrativly down then it cease to accept commands, it just freezes
I currently have it set to use
96008n1
serial /dev/ttyS0
but when I execute this it wants to initialize modem
??? what gives I never had this happen before?
any tips
when i hyperterminal to the router through Hyperterminal
it goes through regular boot up and extracts image and goes through interfaces serial interac s0 s1 are administrativly down then it cease to accept commands, it just freezes