Configuring LS on ASU II

[T8keiteasy]

Hi,

I read that LS on ASU's needs to be configured.
Do you know where I could have more informations ?

Regards

Now, it's about French users too !!!

 

[nytalkin]

system? s/w?

NO GOOD DEED GOES UNPUNISHED!

 

[T8keiteasy]

ICP 3300 mxe 8.0 UR2

Now, it's about French users too !!!

 

[TheMitelGuy]

In your LS Trunk Assingment forms.

 

[nytalkin]

Connect the ASU to CIM post power it on and the application software is loaded then program ASU through ESM.

NO GOOD DEED GOES UNPUNISHED!

 

[T8keiteasy]

Hi,

Thanks for your answer but my problem is a little bit more complicated than connecting ASU to a CIM port...
Mu LS are configured but no analog lines can't be used thru ASU.
They run ok with embedded LS of the ICP...
I've heard than I need to configure call progress Tone plan and have to detect NA tone detection...
I want to know more about that.

I have to connect LS to boat antenna's, so maybe LS type could be different from each other...

Do you know if a documentation exists ?

Regards

Now, it's about French users too !!!

 

[T8keiteasy]

Using ASU II, you need to use the 24 patch panel, cabling depends on type of card :

* 16 ONS :
1 to 16

* 4 LS+ 12 ONS :
1 to 12 for ONS
21 to 24 for LS


Too bad ...

Now, it's about French users too !!!

 

[kwbMitel]

If you were to give some idea as to what is not working it might simplify things.

It looks like you know something of the programming so it isnt fair to make us guess what is wrong.

Examples:

Can you direct trunk select and get dialtone?

Can you receive calls but not make calls?

What is the status of the ports thru maintenance?

What country/continent are you in/on? (yes it can matter)

GIGO


*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.