Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CONFIGURING FAULT TOLLERANCE IN AN ARRAY

Status
Not open for further replies.
justatad

justatad

Programmer
Sep 20, 2001
19
0
0
US
I need to set up two ISA Servers (in 1 array) for fault tolerance (if 1 server goes down the other takes over).

Could someone step me through this? If not, are there any good articles out there on this? Does anyone have any advice on some common mistakes that should be avoided?
 
Status
Not open for further replies.

Similar threads

Sameer258
  • Locked
  • Question
Need Help to Find ip and mac address with email who one open my email
Replies
0
Views
146
Sameer258
Sameer258
acabezas2014
  • Locked
  • Question
Configuring ASA for Network Segmentation
Replies
1
Views
67
acabezas2014
acabezas2014
Sparrow4
  • Locked
  • Question
AnyConnect + Azure + SAML
Replies
0
Views
103
Sparrow4
Sparrow4
Tommy_T
  • Locked
  • Question
Sonic wall - Have an issue remotely connectioning VNC and SMB (and AFP) to one of the 2 ISP circuits
Replies
1
Views
121
nnaarrnn
nnaarrnn
AllenH12
  • Locked
  • Question
Bandwidth in Cisco ASA 5505
Replies
2
Views
126
AllenH12
AllenH12

Part and Inventory Search

Sponsor

Back
Top