Configuring Cisco IOS Static NAT

[Nightcrawler]

Is there a way to configure in Cisoc IOS static NAT entries that inside local source address is translated to global source 1 when going out on one interface1, and to global address 2 when going out on interface2?


I have one ip nat inside and two ip nat outside interfaces.


Thanks

Ed

 

[jeter]

Lets make sure I'm clear here. There are 2 serial interfaces and you want to ba able to specify a route to each?

insert a config ( sh run ) minus the passwords. Jeter@LasVegas.com
J.Fisher CCNA

 

[Saeed42]

Try this page

http://www.cisco.com/warp/public/556/12.html

 

[Nightcrawler]

Right - I have three interfaces. One is to the inside, two are to the outside. However I need a inside ip address to have two different static addresses. IE I need that machine to look like one address down one interface and another on the other interface ....

Thanks

Ed

 

[l3stuff]

You configure each of the interfaces as the "outside", interfaces, when traffice (based on CEF etc) gets forwarded the output interface address will be used to swap out the "inside" source address..

hope it helps...