Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

configuring cisco ata for use of external strobe light and bell

Status
Not open for further replies.
jm9776

jm9776

Technical User
Aug 21, 2005
16
US
I have a client who needs to have a strobe light and external bell ring to notify warehouse workers they have a call. I have seen this done through an cisco ata before i believe and just wanted to get some feedback if their is a better way of doing this and if their is a specific way i should configure the ata. Also does anyone know if their is a specific vendor strobe that i should use. Any feedback would be greatly welcome.

Thanks.
 
Status
Not open for further replies.

Similar threads

mikedphones
  • Locked
  • Question
MASS - Looking for a Cisco Call Manager support tech to move and reconfigure
Replies
0
Views
303
mikedphones
mikedphones
DTGMI
  • Locked
  • Question
Cisco ATA-191-K9 vs 3PW Mod
Replies
1
Views
369
gnrslash4life
gnrslash4life
Gnjiro
  • Locked
  • Question
Cisco Ip Phone 7841, 7821 Delay when making call both inbound and outbound in sip protocol
Replies
3
Views
355
thepfy
thepfy
smrikard
  • Locked
  • Question
Need Unity OVA install file for ISR 4331
Replies
1
Views
306
smrikard
smrikard
Russell35674
  • Locked
  • Question
Cisco VG310/320 migrate from SCCP to MGCP
Replies
1
Views
322
whykap
whykap

Part and Inventory Search

Sponsor

Back
Top