Configuring a D100 for PRI - DID

[Glencom]

Does anybody know if there is a tech document on how to configure a Legend / Magix for PRI.

I got the D100 card configured for PRI/ESF/B8ZS/ and SwitchType 5ESS.

I just don't understand what i need to put in for
LinesTrunks\PRI\PhoneNumber
LinesTrunks\PRI\DailPlanRTG
LinesTrunks\PRI\TestTelNum

or a document that explains these items, the old Lucent docs i have are not that informative

 

[t3chhelp]

These settings are different for different applications. In LinesTrunks\PRI\Phone number- This is where you would set what number is seen on the other caller id end. You could set it for by extension, by line number or by base number with extension number. DialPlanRTG is where you can change DID's. I believe you have up to 15 entries. For example your main DID number ie number to match 1234 digits delete- 4 add digits-771 to go to Autoattendant or 4000 if your reception is different than 1234. TestTelNum is a number you insert when doing a test with the telco provider and is usually not required. Depending on what type of switch the telco provider is there is alot of other settings you would have to change to make the system communicate with the telco. Have fun. There are technical documents on Avaya's website in pdf format explaing what each parts does. Have fun.

 

[ScoTTeL]

I have a 11 step setup instruction for PRI from Avaya help center. I just went through setting one of these up. Email me at EScoTTeL@juno.com and I will attach it and send to you.