Does anyone have some quick steps on configuring an 800 DID module? I just got a used module and want to order some circuits and get DID working. I've got documentation but doesn't seem to be as simple. Also - I assume the only thing that works with this module is analog DID circuits from telco?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Configuring 800 DID Module
- Thread starter BURLYMAN
- Start date
You can "Massage" the digits somewhat by Deleting and/or Adding digits to fit your dial plan and what they are sending you.
The best thing is to do some Pre-Planning with the Telco ahead of time to shop around to try to get the DIGITS they say they can send to fit your dial plan. Or vice versa.
The best thing is to do some Pre-Planning with the Telco ahead of time to shop around to try to get the DIGITS they say they can send to fit your dial plan. Or vice versa.
You assume correctly. There are a few of things to do:
1 - Assign the DID trunks to a block
2 - set them to wink start
3 - Decide what digits you are going to manipulate, or take them straight from Telco.
4 - Set them to touch tone.
5 - Set the number of incoming digits
This is all done under the DID menu in WinSPM or from the programming console.
Pepperz@charter.net
1 - Assign the DID trunks to a block
2 - set them to wink start
3 - Decide what digits you are going to manipulate, or take them straight from Telco.
4 - Set them to touch tone.
5 - Set the number of incoming digits
This is all done under the DID menu in WinSPM or from the programming console.
Pepperz@charter.net
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question