bananashake
Technical User
I would like to know how to setup a 3com Superstack II Netbuilder router with the following parameters using a consol (step by step) as our networking admin is away and we cannot contact him:
Basically, the router needs two interface addresses and a routing rule.
I need to know how to create a rule and how to enter the IP addresses into the router. There are a number of IP addresses I have been given but I know that there is one for the V.35 port, the network port and a subnet mask for each. We have a network but need to connect to a customers network for maintenance.
The setup is as follows: Our local area network > Our cisco router > uunet inetrnet connection > (this is were I need the router configured for)> customer network > LAN pc's for software maintenance.
please inform if more info is required!
Thanks!!!!
Basically, the router needs two interface addresses and a routing rule.
I need to know how to create a rule and how to enter the IP addresses into the router. There are a number of IP addresses I have been given but I know that there is one for the V.35 port, the network port and a subnet mask for each. We have a network but need to connect to a customers network for maintenance.
The setup is as follows: Our local area network > Our cisco router > uunet inetrnet connection > (this is were I need the router configured for)> customer network > LAN pc's for software maintenance.
please inform if more info is required!
Thanks!!!!