Hi there
I got a question here, I got 2 incoming analog line and i got 3 card in my TDA100. those card are CLCOT8, DLC16 and MCSLC24. Our plan is to have 2 group of extension into 2 number yet still can connect internally. I has plug the incoming line 1 into CLCOT8 and another 1 in MCSLC24 in the PFT port on both card. However, i can only see there were only 1 incoming line in the console where it only state the incoming were only at CLCOT8 as shown below.
My question is how do i have 2 incoming line within my setup. Do I need to get another card such as another CLCOT8 for the incoming line instead of MCSLC24 as the DLC16 can cater enough extension for the 1st incoming line. Assuming i need to buy another CLCOT8 card, can i tag the MCSLC24 to the new CLCOT8 to create the extension line for another line. Does the extension in both group are able to connect each other even in different incoming card?
I got a question here, I got 2 incoming analog line and i got 3 card in my TDA100. those card are CLCOT8, DLC16 and MCSLC24. Our plan is to have 2 group of extension into 2 number yet still can connect internally. I has plug the incoming line 1 into CLCOT8 and another 1 in MCSLC24 in the PFT port on both card. However, i can only see there were only 1 incoming line in the console where it only state the incoming were only at CLCOT8 as shown below.
My question is how do i have 2 incoming line within my setup. Do I need to get another card such as another CLCOT8 for the incoming line instead of MCSLC24 as the DLC16 can cater enough extension for the 1st incoming line. Assuming i need to buy another CLCOT8 card, can i tag the MCSLC24 to the new CLCOT8 to create the extension line for another line. Does the extension in both group are able to connect each other even in different incoming card?