Configuring 1841 Router

[iridiumnet]

Hi All,


I'm having issues configuring my 1841 router for internet access and I thought I'd come here for some advice.


Here's what I would like to do:


On interface fa 0/0 I would like it facing the cable modem to internet, I have a static IP address with my ISP.


On interface 0/1 I would like this to face my internal network and connect it to an unmanaged switch with all the internal servers having 10.10.10.0 I.P's


I would like to allow ALL traffic to pass through the router both incoming and outgoing, I don't need to use ACL's because I will use a firewall on certain servers as needed.


I did mention I followed some tutorials on the internet of how to configure the router using NAT, I was able to connect out to the internet but wasn't able to connect back to any servers in my network (web, mail etc) so I reset the router back to factory set and would like to start from scratch.


Can anyone give me an idea of how to configure the router for this?


Thanks!

 

[unclerico]

put your ip nat inside and your ip nat outside statements back in and then add NAT statements like this:

ip nat inside source static tcp 10.10.10.1 25 int f0/0 25
ip nat inside source static tcp 10.10.10.2 80 int f0/0 80

I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)