Configure serial connection from H50 running 4.3.3

[splitting10]

I need to run a serial connection from an H50 running 4.3.3 to a SunFire v100. The H50 has 3 serial ports on the back but I'm not sure of the command to use to connect to the SunFire v100. On a Sun server I would use the "tip" command. What is the equivalent command on AIX? Any tips for setting this up?

 

[gilsont]

[TT]

If you want to access the service processor of the H50 use ports S1 or S2. Otherwise use port S3.

Use a null modem cable to do the physical connection.

You should be able to use 'cu' on the H50 to get a connection - you may need to install bos.net.uucp in order to get 'cu'.

Use 'smit tty' to configure the TTY. Use 9600,8,1,0 and hardware flow control and you should be in business.