Ok guys, I have a DLS connection, a NETOPIA 3360 cable modem, a Linksys wireless router and 4 pcs connected to the router.. I am using private IPs in the 10.x.x.x range... I have a block of static IPs from my ISP which I am not using right now... I would like to know how to configure the Linksys to do NATting. To use myy private IPs on my LAN but be able to access my machines from the outside by RDP.. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Configure NAT
- Thread starter ciscotx
- Start date
Remote Desktop uses TCP port 3389. In the Linksys router's port forwarding page, forward TCP 3389 to one of the PC's private 10.x.x.x addresses. Then from outside your network, use the RD client to connect to whatever public IP address the router is using.
If you want to RD into multiple machines without reconfiguring the router, you'll need to set each RD system to listen on different ports & configure the router accordingly. thread916-1205175
If you want to RD into multiple machines without reconfiguring the router, you'll need to set each RD system to listen on different ports & configure the router accordingly. thread916-1205175
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question