Configure my Cisco 678

[Guest_imported]

Hi, How can i configure my router (cisco 678)
so when i do a telnet session it ask me for the password, because i'm trying to do that but the only the routers ask me is the password, and then i'm in!!

What can i do? what password can I used it?

thanks!!

O. Benjamin

 

[jeter]

From Global
line vty 0 4
login
password ( password )
dont forget to save your config J.Fisher CCNA
Jeter@LasVegas.com

 

[cbum]

Hello.

Take a look at the URL below, it shows how to setup
exec and enable password ( the Cisco 675 and 678 use the
same command's).

http://www.cisco.com/warp/public/794/675login.html

Complete documentation at

http://www.cisco.com/univercd/cc/td/doc/product/dsl_prod/c600s/c678/678inop/04chap03.htm

You should set exec password and enable password for
proper security.


Note: The Cisco 678 uses an operating software called CBOS.
The command's listed below will not work because they are for an Cisco IOS Router, so the Cisco 678 will not understand the command's

================This command is for Cisco IOS routers====
line vty 0 4
login
password ( password )
dont forget to save your config

===========================================================

 

[jeter]

See we all can learn from this site. I was only aware of the cisco 700 series having a differnet image. I'm going to
have to check ot those sites. J.Fisher CCNA
Jeter@LasVegas.com