configure CP100 1

[Vernon1416]

Trying to configure CallPilot 100 with the Quick Wizard install, using a cross over cable. IP address for Call pilot 192.168.110.10, pc ip address with crossover cable 192.168.110.11. I can ping the Callpilot 100 ok.
but cannot pull it up in my browser to configure.

instructions as follow: type the ip address in browser to start the qick install Wizard. When i do this the page cannot be displayed.


any suggestion for cofiguring the CallPilot 100

 

[mroberts]

Is this a new brand new install of a brand new CP. This will happen if you have the wrong IP address. This CP hasn't been changed in anyway, has it?



MRoberts
mroberts@americaii.com

http://www.a1teletronics.com

 

[senk1s]

what happens when u do a feature 983 in a phone?
can u login succesfully?
if not you have a bad callpilot - if you can login from the phone - make sure ur PC OS/ browser is compatible

 

[mroberts]

Don't trash it just yet. Just check the IP addy.

To Change the IP address of a CallPilot Via a Serial Cable

Power down the CallPilot

Start Hyperterminal.

1. My Computer
2. Double Click on your C drive.
3. Double Click Accessories.
4. Double Click HyperTerminal Folder.
5. Double Click HyperTerminal Icon.

It will bring up a connection screen:

6. Type in CallPilot for the name and leave the first icon selected. Click OK.

It will bring up another screen:
Ignore everything except the “Connect Using” Field.

7. Click on the drop down menu.
8. Choose Com 1.
9. Click OK.
10. Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: Hardware

11. Click ok.
The COM properties window will close and you will see a white HyperTerminal screen.

12. Power up the CallPilot.

In about a minute or so a lot of information will scroll up the screen. Eventually you will see it prompt:
To change any of this press any key within 2 seconds.

13. Quickly press the space bar.

14. The prompt (M)odify any of this or (C)ontinue? appears.

15. Press the M key and then Enter.

16. Do you want a LAN interface? Press Y then Enter.

17. This board’s LAN IP Address (0.0.0.0 – RARP). Type in the desired IP address.

18. Subnet mask for LAN (0 for none) Usually 255.255.255.0 will appear automatically. Just hit Enter.

18. Should there be a default gateway for packet routing? If this CallPilot needs a Next Hop Router, press Y then Enter. If this CallPilot doesn’t need a Next Hop Router, press N then Enter.

19. IP address of default gateway? If needed type in the address of the Next Hop Router. If not then just hit Enter.

20. The system will prompt you to change a few more parameters, JUST PRESS ENTER UNTIL THE SCREEN SHOWS:

(M)odify any of this or (C)ontinue?

21. Press C and then Enter.

You can now Close out of HyperTerminal and disconnect your serial connection. Connect your Ethernet cable to the CallPilot and the other end to the laptop.


MRoberts
mroberts@americaii.com

http://www.a1teletronics.com