Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

configuration Automatic Wake UP from Succession comunication server rls 4.0

Status
Not open for further replies.

mrgarcia100

Technical User
Jan 26, 2013
3
GT
Dears,

request your assistance Wake Up settings in Nortel CS1000 rls 4.0
I am certified engineer with over 10 years experience, though still reading the manual does not understand some concepts and is the first time that I set wake up.

for this solution I have installed card MIRAN for digital anounces.
I set up and connect with PMS (OPERA) but my confucion do not understand how to set RANF trunk and routes as well and as routes RANF RAN1 and RAN2 in MIRAN card.

I welcome your ideas and experience to solve these doubts, and whether it is possible to configure this service.

sincerely

Mario Garcia



The following is a summary of the tasks in this section:
1 LD 16 – Define the RANF route.
2 LD 16 – Define the RAN1 route.
3 LD 16 – Define the RAN2 route.
4 LD 14 – Define the trunk for RANF.
5 LD 14 – Define the trunk for RAN1.
6 LD 14 – Define the trunk for RAN2.
7 LD 15 – Enable Automatic Wake Up in Customer Data Block.
8 LD 10 – Set language and CCOS for analog (500/2500 type) telephones
(on a per TN basis).
9 LD 11 – Set language and CCOS for Meridian 1 proprietary telephones
(on a per TN basis).
10 LD 12 – Allow access to AWU from Attendant Consoles.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top