Config Of DASS Trunks

[mdnewey]

Hi,

I have a DASS2 circuit that was used purely for outgoing calls and now want to route incoming calls over it and before I get BT to present my DDI range from my other DASS2 circuit over this one as well, I wanted to checked that channels are configured for bothway working and the number of digits it expects to receive from the network.

What commands should I enter to check/amend if necessary?

Thanks

 

[Isinor]

Hi mdnewey,

ROCAP:ROU=...;

Look at SEL digit 2
0 = Barred for incoming traffic
1 = Open for incoming traffic

Also SEL digit 1 (Add digits if more than one service is required)
0 = No ReRouting DDI
1 = ReRoute on vacant etc
2 = ReRoute on busy
4 = RerRoute on No Amswer

To change values...
ROCAC:ROU=...,SEL=...;


If DDI numbers need to be converted... look at NUTRI command.

Regards
Isinor