Config CO trunk card TN info.

[nutek10]

I am config a CO Trunk card and when attempting to do LD 13 and LD 14 in Option 11C I get stuck!

Both overlays are asking for a TN, the COT is placed in slot 2 and has 8 ports.
Therefore I am trying to put
TN = 3 0 Card=3, Unit= (0 to 7)

What am I do ing wrong and whta is the correct way to insert the TN paramaters.
Help please.

 

[PERRYPJ]

TN 2-0 THROUGH 2-7 FOR SLOT 2

OLD ROLMEN WORKING ON NORTELS

 

[johnpoole]

you don't need load 13 to set up a trunk.. might help. that is for a dtr card, which you already have.. ld 20 prt dtr.. you'll see about 8, that's more then you'll need for 100+ trunks.. only used for tones a few seconds per call. the tn 2 0 is card 2 port 0.. do a stat against any trunk card that is in service and you'll see ports 0 thru 7 prt one of those tn's

DES COT
TN 004 1 15 02
TYPE COT
CDEN 8D (default after 1st unit)
CUST 0
XTRK XUT (default after 1st unit)
TIMP 600 (default)
BIMP 3COM (default)
TRK ANLG (default)
NCOS 0 (set on a need basic ncos 0 here prevents dial thru)
RTMB 4 3 (route 4 was built for cot trunks in this group)
NITE (don't want it to change term points during nite service)
SIGL GRD (start type agreed upon with carrier)
SUPN NO ( i don't expect )
AST NO ( default)
IAPG 0 (default)
CLS UNR DTN CND WTA LPR APN THFD
P10 NTC LOL (only change is unr dtn)
TKID

this is pretty standard for a analog trunk ground start

john poole
bellsouth business
columbia,sc

 

[nutek10]

perrypj....
I tried as you mentioned but it does not seem to take it, keeps jumping to the next line with a TN

TN 2-0
TN 2 0
TN 2

none of the above works.

 

[johnpoole]

this is all the commands you need to add a cot.. ld 14 (6 seconds)

REQ new
TYPE cot
TN 4 1 15 7
DES temp
XTRK XUT
CUST 0
NCOS 1

RTMB 22 1
NITE
SIGL lop
TIMP
BIMP
SUPN
AST
CLS dtn
TKID



john poole
bellsouth business
columbia,sc

 

[techman3030]

try putting in the full tn
2 0 0 0
I know it's an opt 11c, and you're not supposed to have to do it.
also stat card 2 and make sure nothing is already assigned to it.

 

[nutek10]

Thanks for all the help guys!

 

[johnpoole]

i didn't think an 11 knew what to do with loop and self?...

john poole
bellsouth business
columbia,sc