compiled report for CR 8.5 failure

[RobStead]

Setup.exe created by CR 6.0 will install successfully on a NT 4.0 workstation. But, I can not get a setup.exe created by my new ver. 8.5 upgrade to finish installing. The install gets to the very end stating that it's updating the system and then displays a Dr. Watson error. I have recreated this symptom on 2 other workstations. Has anyone either successfully run the 8.5 distribution expert in an NT 4.0 environment or seen this same problem and overcome it?

Thanks,
Rob

 

[HowardHammerman]

I have been able to run a compile report from Version 8.0 on a Windows NT workstation, no problems.

Crytal warns us against using compiled reports..... Howard Hammerman,

Crystal Reports training, consulting, books, training material, software, and support. Scheduled training in 8 cities.
howard@hammerman.com

http://www.hammerman.com

800-783-2269