Commands for 2948G

[jchelpdesk]

WS-X2948G-GE-TX

Question 1 I am trying to get the interface details. The command
"show interface port-channel 1" should have done the job and produced the information but it is not working. I get the Usage: "show interface [trap]" message.

Question 2 Trying to get the mac address table of attached devices. Show mac command produces something else. Tried show cam dynamic but the mac addresses were not attached to the device.

Thanks for you assistance.

 

[vipergg]

The 2948G is a old catos box and does not run IOS so those commands will not work . You can try something like show portchannel X , or show port . show port couters will give you errors and or traffic details.. Show cam dynamic should show you the mac adresses of any attached live device. I think show cam slot/port will give you a mac for a specific port. For the most part all commands will start with "set" or show .