Command parameter changes name when used with report parameters

[PNC]

Hi,

Here's my problem, I have a command parameter for my query and I also have report parameters, so when I create a report parameter with a dynamic list of values, the name of the command parameter changes when I run the report in the prompt screen, it displays the name of the report parameter with the dynamic list of values.

Example:

Enter QueryParameter:                ReportParameterName1
[                                                       ]

Enter ReportParameterName1:           ReportParameterName1
[                                                        ]

Enter ReportParameterName2:           ReportParameterName2
[                                                        ]

Any ideas why? Is this a bug in Crystal Reports XI?

Thanks.

 

[DarthGAD]

Can you post the full code for the Command?

From my experience, if you create a command parameter it becomes available for you to use in the report. Are the names of the command parameter and the report parameter the same? If so, that may be the problem. I have not tested this however.

 

[PNC]

The code is not the problem, it's a bug in Crystal XI, it has been discussed in this thread also

http://www.tek-tips.com/viewthread.cfm?qid=1157169

The only solution I found so far is not to use a command parameter along with a report parameter with a dynamic list of values.

Thanks for your reply.