command for busy and release trunk in Cs 1000

[Sijuadoor]

Hi Guys,

I need a suggestion that 2 trunk group were all the channels are showing MBUSY.
I want to make this as "IDLE"

I know this can do in Ld 60. What could be the steps enable me make the trunk up?
One is Tie trunk and other DID
PRI2 LOOP 135 - ENBL
REF CLK: DSBL
SERVICE RESTORE: YES
ALARM STATUS: ACCEPTABLE
CH 01 - MBSY TIE VOD * CH 02 - MBSY TIE VOD *
CH 03 - MBSY TIE VOD * CH 04 - MBSY TIE VOD *
CH 05 - MBSY TIE VOD * CH 06 - MBSY TIE VOD *
===========================================================
PRI2 LOOP 129 - ENBL
REF CLK: DSBL
SERVICE RESTORE: YES
ALARM STATUS: ACCEPTABLE
CH 01 - MBSY DID VOD * CH 02 - MBSY DID VOD *
CH 03 - MBSY DID VOD * CH 04 - MBSY DID VOD *
CH 05 - MBSY DID VOD * CH 06 - MBSY DID VOD *
CH 07 - MBSY DID VOD * CH 08 - MBSY DID VOD *

Regards,
Siju

 

[Firebird Scrambler]

If I recall correctly, you need to disable the channels first in LD 60 with DISC 135 etc
Then go into LD 17 and disable the associated D channel.

Now enable the D Channel in LD 17 and go into LD 60 to e.g. ENLC 135 etc.
It's been a few years since I last did this, so I could be wrong!.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.net

linkedin

 

[KCFLHRC]

Looks like you have a clock issue as well

 

[Qamar177]

Follow these steps to Up the trunks.

1. Go to LD 96
2. Disable associated D-Chaneel ie DIS DCH xyz.
3. Go to LD 60
4. Disable concern loop ie DISL 135
5. Now enable the loop ie ENLL 135.