comdial excutech no ring at stations for incoming calls.

[nuetek]

comdial excutech have four lines with 5 phones/ incoming calls the light blinks but does not ring at any phone. please help

 

[stsguy]

ARE YOU FAMILIAR WITH THE PROGRAMMING?


WORK SMART NOT HARD

 

[nuetek]

is it (ITCM) - (*)(7)(4)(6)(*) from station 10 ?
need to know if that is right and what next

The system is comdial executech 824 KSU it has 4 stations. station 10 does not have a display. all the phones are the same. ii have attached pic of phone

also non of the phones show their extension

also need to set up the intercom ring also

Thanks

 

[stsguy]

intercom *#746*. dial 54. dial 1. Select lines to ring using the A1-A14 buttons. A1 is the top left button, this would be line 1. dial # dial ext #. dial *** when done.

WORK SMART NOT HARD

 

[nuetek]

ty
will try that out today. when i do the ring for station 10 do i still need to enter the ext.

how do i setup the night mode?

thank You

I was a member of this site about 2yrs ago. Always used it at my job. This site has always been extremely helpful and I have learned so much here. Just wanted to thank people like you that take the time help.

 

[stsguy]

YES, YOU HAVE TO ENTER THE STATION NUMBER. I DON'T THINK THAT OLD SYSTEM HAS A NIGHT SERVICE. YOU MAY HAVE TO USE CALL FWD

WORK SMART NOT HARD

 

[TouchToneTommy]

For an 824, you can download the manual here:

http://www.wedophones.com/Manuals/comdial/ExecuTech/ExecuTech II Model 816-824.pdf

Look starting at page 60 for Station COS programming

At Ext. 10,

Intercom *746*
Dial the extension number that you want to program
Press 2
(At this point, ALL lines on that phone will be set to NO ring)
Press EACH line button that you want to make ring on the set
Press * when you are done with that extension

Dial another extension number, or press MONITOR to exit