We recently upgraded from Accpac 5.0 to 5.1 (along with Win 98 to Win XP and Office 97 to Office 2K at the same time).
Since then, when trying to run FR in the design mode, the column widths change almost every time you run it. They get bigger and Bigger and BIGGER. If you ran the same spec 3 consecutive times, the column widths could end up being huge (100 units). Sometimes, the column widths dont' get bigger...they get smaller and smaller and smaller until they're all 1 unit wide. It is EXTREMELY frustrating to have to reformat all your column widths every time you want to run the report on a different account segment.
Has anyone else seen this and have any suggestions?
Desperate,
Julica
Since then, when trying to run FR in the design mode, the column widths change almost every time you run it. They get bigger and Bigger and BIGGER. If you ran the same spec 3 consecutive times, the column widths could end up being huge (100 units). Sometimes, the column widths dont' get bigger...they get smaller and smaller and smaller until they're all 1 unit wide. It is EXTREMELY frustrating to have to reformat all your column widths every time you want to run the report on a different account segment.
Has anyone else seen this and have any suggestions?
Desperate,
Julica