Code Page and W2K

[stevehunt154]

Since I upgraded to W2K, I get an error on starting Dbase 5.0.

"System not configured for current code page settings"

I press continue and all works normally as far as I can see.

Where can I change the setting to remove this error?

 

[ormsk]

Hi

I don't have vers 5.0, but the same problem used to happen on vers 2.0.

Basically, you can either live with it, or re-install (checking what your current code page setting is prior ti installation).

To check code page, from a dos window type CHCP. This will return the code page of your system.

No harm is being done while you are running on different codepages. It is just that some 'graphics' within dbase may appear differently (like a rectangle that has a strange character in the corner, or something like that)l Your data will be ok.

HTH