CO Ring at Remote System

[clementlimpotel]

Hi

I have two LDK60 systems that is networked and I need the first system's CO lines to ring at branch 2

My extension numbers as follows:

Branch 1 : 100-147
Branch 2 : 200-247

I can transfer calls between the two and I also use the CO's from branch 1 to make all outgoing calls at branch 2. That works fine.

I have tried to set the CO RING ASSIGNMENT to ring on NET200 at branch 1, but it cuts off all calls.

Any advise?

 

[montyzummer]

to sanity check your set up can you setcan unconditional forward from a station at branch a to a station at branch b make the call and get succses

if you can then point the trunk at the forwareded station and test from there you can start trouble shooting further

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[clementlimpotel]

Hi

I can set unconditional forward. It works if I forward an internal station from system A to System B, however if I forward the main attendant it still cuts.

Here is what happens. I forward station 100 (Main Attendant) to Net200. I can see on the DSS buttons, that when I dial into the CO, it picks up the VoIB channel to terminate the call to Net200, but then I get engaged tone. It is almost as if system B does not exept the call and then terminates.

 

[clementlimpotel]

Hi again..

Any other advise?

I don't have CLI activated from my Telco provider. Does it make a difference. I suspect there could be something wrong with the network numbering plan?