CO Line ringing

[6453]

Hello,

Thank you in advance for any help you might be solving my problem. First let me say I am a nortel guy. have searched this forum, read the system admin manual, and the station manual and have not been able to find the answer.

I have a customer that has a TD1232 and they want all co lines to rings at a few stations. They have about 25 stations and they want all 8 co lines to ring at three different stations. Each of the stations has enough CO line keys.

Thanks again for any help you might offer.

 

[rivet]

into system prog no: 603 (day ringing)
604 (night ringing)
in the manual it is called dil 1to n:

Extension Programming
DIL 1:N Extension and Delayed Ringing — Day / Night
603-604
System Programming 4-129
Description A DIL 1:N line can be assigned to ring more than one extension.
All incoming calls from the programmed CO lines are directed to
the specified extensions. These programs assign the extensions and
the notification method for each CO line in both day and night
modes.
Selection • Jack number: KX-TD816 – 01 through 16, (-1 / -2),
KX-TD1232 – 01 through 64, (-1 / -2),
( =all jacks, -1 = first part, -2 = second part)
• CO line number:
KX-TD816 – 01 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• Disab (disable) / Immdt (immediate ringing) / 2RNG (2 ring
delay) / 4RNG (4 ring delay) / 6RNG (6 ring delay) /
8RNG (8 ring delay) / No RNG (no ring)
Default All jacks-1/2 – all CO lines – Immediate ringing — Day / Night
Programming 1. Enter a program address (603 for day or 604 for night).
Display example: DIL 1:N Asn Day
2. Press NEXT.
Display: Jack NO?–>
3. Enter a jack number.
To enter jack number 01, you can also press NEXT.
To select the second part (-2), press NEXT after entering a jack
number.
Display example: #01-1:CO01:Immdt
4. Enter the CO line number.
You can also keep pressing or until the desired CO line
number is displayed.
5. Keep pressing SELECT until the desired selection is
displayed.
6. Press STORE.
7. To program another jack, press NEXT or PREV, or SELECT
and the desired jack number.

this is one way but it depende if you want grp ringing
but it will get you started


peter

 

[rivet]

also in this section of the programing

4. Enter the CO line number.
You can also keep pressing or until the desired CO line
number is displayed.
5. Keep pressing SELECT until the desired selection is
displayed.
6. Press STORE.

if you press the * button it will prog all the lines at the same time