CO group 88 enable DID digits

[CassidyHunt]

I have a CO group 88 that I need to setup to interpret DID digits. Does anyone know how to do this?

 

[Fixin]

What system?

 

[CassidyHunt]

NEAX 2000 IVS 2

Sorry. I should had included that upfront.

Cassidy

 

[Fixin]

In the trunk route for your DID's be sure to flag 3518>route>0. Then in CM 7600>DID No>bin No. CM 7601>bin No>ext. No (for day mode) and CM 7601>bin No.>extention No. (for night). Also be sure the actual DID is assigned in the numbering plan as a station. Hope this helps!

 

[CassidyHunt]

I am really new to programming the NEC. Most of my experiance is actually Vodavi and executone. I know how to get to 3518 but I do not know if I am in the right trunk group. I hate to ask this but could you tell how to do this? I get into programming conf, trans, *, conf, Trans, #, then ST.

From here I know I can type 3518 DE but I am not sure what group I have or really what I am looking at. Normally I would have the innerconnect do this but they are really unresponsive and have always been. So I am trying to get it figured out on my own. We are currently looking for a new vendor for this.

I really appreciate the help.

Cassidy