Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CNA shows device as "Wireless Client" when it's not

Status
Not open for further replies.

disturbedone

Vendor
Sep 28, 2006
781
AU
For the first time in a while I used CNA 5.6 and it showed a recently installed 2960S had an 'unknown device' attached to it and it had a long, what appeared to be a, serial number. I thought this was odd so I upgraded to CNA 6.1 and it now shows the long serial number but it shows it as a 'wireless client'. I do have a non-Cisco WiFi controller attached to this switch so I thought somehow it might have detected this. But clicking on this device shows that it has Device Type as PCM6348, an IP address and the hostname is the long serial number. I recognised the PCM6348 & IP address as the Dell switch that is in the Dell M1000e blade chassis to which the 2960S is connected, the serial number is the serial number of that 6348 switch.

Any ideas why CNA would be detecting a Dell switch as a 'wirelesss client'?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top