Just a quick question ...
We have reprogrammed the IDPROM NVRAM on older ULTRA and SB100s - probably running on OpenBoot 3.x and the mkp command always worked easily to reset the ethernet and host ID - SN
We just replaced the battery on a Sunblade 150 and am trying to reprogram the IDPROM
In the past we just ran these basic commands w/ the applicable ETH and Serial # data added.
Problem is that the mkp command returns a - mkp ?? result as it doesn't recognize the command?
Is it an OpenBoot version issue? This SB150 is running on OB 4.6 I believe
1 0 mkp
83 1 mkp
8 2 mkp
0 3 mkp
20 4 mkp
c0 5 mkp
ff 6 mkp
ee 7 mkp
0 8 mkp
0 9 mkp
0 a mkp
0 b mkp
c0 c mkp
ff d mkp
ee e mkp
0 f 0 do i idprom@ xor loop f mkp
We have reprogrammed the IDPROM NVRAM on older ULTRA and SB100s - probably running on OpenBoot 3.x and the mkp command always worked easily to reset the ethernet and host ID - SN
We just replaced the battery on a Sunblade 150 and am trying to reprogram the IDPROM
In the past we just ran these basic commands w/ the applicable ETH and Serial # data added.
Problem is that the mkp command returns a - mkp ?? result as it doesn't recognize the command?
Is it an OpenBoot version issue? This SB150 is running on OB 4.6 I believe
1 0 mkp
83 1 mkp
8 2 mkp
0 3 mkp
20 4 mkp
c0 5 mkp
ff 6 mkp
ee 7 mkp
0 8 mkp
0 9 mkp
0 a mkp
0 b mkp
c0 c mkp
ff d mkp
ee e mkp
0 f 0 do i idprom@ xor loop f mkp