CMS RAS access

[nx9005]

please could someone tell me how to set up remote dial in access to cms,its sunblade 150

i have connected a serial modem and it answers but dosent prsent avaya a log in prompt

thanks in advance

 

[mrnoisy]

Do you know which serial port it is, ttya or ttyb?

To check to status of the serial port(s), type the command;
/cms/install/bin/abcadm -k

You should get a response like the following;

console set to local
/etc/ttydefs remote console baud rate set to 9600
ttya is set to incoming at 9600 baud
ttyb is not administered or is output[/color blue]

To remove incoming modem from port ttya, type the command;
/cms/install/bin/abcadm -r ttya

To set up a 9600 baud incoming modem on port ttya, type the command;
/cms/install/bin/abcadm -i -b 9600 ttya

Alternatively, if you are on the console, you can run the following command;
admintool&

This will bring up a GUI from which you can view/edit your serial port(s).