CMS add second interface eth2 with static route

[Wolfdzn]

is there any instructions available to add second interface in CMS eth2 with the static route ? etho is working fine but need to add eth2 to connect with CM which is is different subnet

 

[jimbojimbo]

Previously it was standard practice to have 2 ethernet interfaces. One for the switch link directly to a CLAN and one for Administration/CMS Supervisor clients. This is no longer the case. You should be able to run both PBX systems off one interface assuming you are on a routable network.

There's no actual documentation I'm aware of. Assuming you are on a current version on Linux it is standard Linux Administration. I have typically used S99local (I think there's actually an S99.... Avaya specifically uses) to add the static route for the secondary interface to insure it survives over reboots.