Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
cmd hangs
- Thread starter mohmin
- Start date
Hmm, are you running AIX 5.2 ML 3, 4 or 5 ?
Is the system frimware old ?
Check here for firmware updates:
Is the system frimware old ?
Check here for firmware updates:
- Thread starter
- #3
MoshiachNow
IS-IT--Management
Also :
1.check "errpt" output - watch out for disk/tape/HW errors.
2.Run "cfgmgr -v" and see if it sticks and where.
3.Check "df" for any full FS.
Long live king Moshiach !
1.check "errpt" output - watch out for disk/tape/HW errors.
2.Run "cfgmgr -v" and see if it sticks and where.
3.Check "df" for any full FS.
Long live king Moshiach !
to check your firmware level:
lsmcode
or
lscfg -vp|grep Cabinet
*warning*
either of these commands may hang or even hang the system if you have the above problem.
check the ML first to see if you are likely to have the problem:
oslevel -r
will tell you the AIX level and the maintenance level.
if you get no output you are running base 5.2, i.e. AIX 5.2 ML0.
lsmcode
or
lscfg -vp|grep Cabinet
*warning*
either of these commands may hang or even hang the system if you have the above problem.
check the ML first to see if you are likely to have the problem:
oslevel -r
will tell you the AIX level and the maintenance level.
if you get no output you are running base 5.2, i.e. AIX 5.2 ML0.
sorry, the above "lscfg -vp|grep Cabinet"
should give you the machine serial number....doh,
for the firmware use:
lscfg -vp | grep alterable
the "description" link on the IBM microcode link above, for your machine type will tell you "How to Determine Currently Installed Firmware Levels" if the above commands do not work.
should give you the machine serial number....doh,
for the firmware use:
lscfg -vp | grep alterable
the "description" link on the IBM microcode link above, for your machine type will tell you "How to Determine Currently Installed Firmware Levels" if the above commands do not work.
- Status
Similar threads
- Locked
- Helpful tip