Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CM AAR to tie trunk

Status
Not open for further replies.

MoJHK

Systems Engineer
Nov 16, 2017
180
HK
Dear experts,

I had a E1 tie trunk to another PABX.
I created a AAR 5900
"Location:","Dialed String","Min","Max","Route Pat","Call Type","Node Number"
"all","5900","4","4","40","aar",""

and it could connect the far end pabx by outbound call

after few weeks I created another AAR 5800
"Location:","Dialed String","Min","Max","Route Pat","Call Type","Node Number"
"all","5800","4","4","40","aar",""

with the same AAR setup but 5800 could not go through the PABX.
I got "denial station" from list trace.
both 5800 and 5900 was the extension number in the far end PABX.

Did I miss something there?

 
Here are a couple of things to check:

Are you using station first or UDP first?

Code:
display dialplan parameters
                             DIAL PLAN PARAMETERS
                 Local Node Number:                     ETA Node Number:
   UDP-ARS Calls Considered Offnet? n               ETA Routing Pattern:
        [COLOR=#EF2929]UDP Extension Search Order: udp-table-first[/color]
 Location-Based Call Type Analysis? n
  Call Type Analysis Behavior When Extension Not Assigned: intercept-treatment

Do you have entries for both 5800 and 5900? Or, is there a more generic dial string of "5" that both can match?

Code:
display uniform-dialplan                                               Page   1

                      UNIFORM DIAL PLAN TABLE

 Matching Pattern   Len   Del   Insert Digits   Net    Conv   Node Num

 [COLOR=#EF2929]5800                4     0                    aar     n
 5900                4     0                    aar     n[/color]

Check how the system dial out 5900 and 5800. Is there any difference in the selected route pattern?

Code:
list aar route-chosen 5800#

                           AAR ROUTE CHOSEN REPORT

     Location:  all                    Partitioned Group Number:  1

      Dialed            Total        Route    Call      Node    ANI
      String          Min    Max    Pattern   Type     Number    Location

 5                    4     4        [COLOR=#EF2929]1        aar[/color]                  all

   Actual Outpulsed Digits by Preference (leading 35 of maximum 42 digit)

 1: 5800                                 9:
 2:                                     10:

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top