Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Clocking alarm

Status
Not open for further replies.

NewNic

IS-IT--Management
Nov 14, 2003
524
US
I had to move a pri to a different slot and change the sync sourse in a G450, When looking at sync timing, both the primary and secondary sourse where happy. But the gateway still showed sync fault.

I ended up re-booting the gateway to clear. Is there a command that i could of used instead? Something not as intrusive

Thanks
 
Did you make the change from the MG or from CM? A reboot shouldn't be necessary.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top