I have a newbie question for you . I have a point to point T-1 down and the CO is telling me its trouble at my A location. I have a LIne Protocol down message and I thought I need to check the clock source on my interface. For the freaking life of me I cannot figure out the command. Clock command on the IF give me the option to set the clock speed/rate on the internal. i need to set the timing to line or internal... can someone help me? thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Clock Command
- Thread starter Aholmes
- Start date
I hope this helps you out....
Controller T1 0/0/0
framing esf
clock source internal
linecode b8zs
channel-group 0 timeslots 1-24
Some people are like slinkies.
Not really good for anything but they bring a smile to your face when pushed down the stairs.
Tek-TIP Member 19,650
![[americanflag]](/data/assets/smilies/americanflag.gif "[americanflag] [americanflag]")
Controller T1 0/0/0
framing esf
clock source internal
linecode b8zs
channel-group 0 timeslots 1-24
Some people are like slinkies.
Not really good for anything but they bring a smile to your face when pushed down the stairs.
Tek-TIP Member 19,650
- Status
Similar threads
- Locked
- Question