CLJ2840 59.C0 error

[Michael52x]

This seems to be a 59.0192 error which is the developing motor.
I am getting a problem with the motor next to the fan on left side. The gear it drives has a tab on it, to be pointed down installing the carousel assy., but the motor winds it up, and then jams up. My question: does that motor go two ways? If so, is it a fault of the motor or the DC cont.? Have replaced all motors and DC cont. RE-seat the carousel and still this issue.
thanks for any ideas, MichaelTech


"Impatience will reward you with dissatisfaction" RMS Cosmics'97

 

[Michael52x]

Got it!
The disengagement assembly, even when seated correctly, and the tab on the white gear is down, it was still 180 out on the cams.
Solution: remove disengaging motor, but leave cable on, and cycle the printer. Then put motor back in, voila!

"Impatience will reward you with dissatisfaction" RMS Cosmics'97