CLIDVER command not printing out in OPT 11

[NT4ever]

I am trying to print in LD 20 of an OPT 11, the type CLIDVER however I keep getting a SCH0099 error code. I was told that the switch needed to be a certain release, but mine is Release 25 so should let me print this. Any suggestions?

 

[KCFLHRC]

That's a new command to me, never used it.

 

[yyrkroon]

CLIDVER x, where x is 0-9999999

 

[KCFLHRC]

I don't see it in LD 20 through 7.5. Maybe the wrong load??

 

[yyrkroon]

>ld 20

PT0000
REQ: prt
TYPE: clidver
SORTBY
ESAONLY
SHORT
CUST 0
DN xxxx - where xxxx is the DN you want, or enter for all DN
DATE
PAGE
DES

DN KEY TN ERL CTYP CLID ROUTE CALLED#
------- ------ ----------- ----- ------- ------------------ ----- ----------------
xxxx 00 SCR 016 0 09 10 0 911 C 952 R 000 911
xxxx 06 SCR 012 0 02 15 0 911 C 9521234567 R 000 911
xxxx 09 SCR 048 0 05 04 0 911 C 9521234567 R 000 911

output depends on release. This is from 7.5. Not sure if it was avail on x11-25.
type = clidver x - this prompt also depends on release. in 7.5 x wasn't necessary.

 

[KCFLHRC]

I'll be damned, learn something new everyday.