Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CLID - Outbound display DID number
- Thread starter Seajumper
- Start date
Johnthephoneguy
Technical User
Configured in LD 15
This is how my table entry 0 is set up, the phonesets default to 0 unless you tell them otherwise. So you have to see how your phones are setup and also your clid table.
ENTRY 0<-- This sends out the actual DID that is calling.
HNTN 301
ESA_HLCL
ESA_INHN NO
ESA_APDN YES
HLCL 555
DIDN YES
HLOC 555
LSC
CLASS_FMT DN
JohnThePhoneGuy
"If I can't fix it, it's not broke!
This is how my table entry 0 is set up, the phonesets default to 0 unless you tell them otherwise. So you have to see how your phones are setup and also your clid table.
ENTRY 0<-- This sends out the actual DID that is calling.
HNTN 301
ESA_HLCL
ESA_INHN NO
ESA_APDN YES
HLCL 555
DIDN YES
HLOC 555
LSC
CLASS_FMT DN
JohnThePhoneGuy
"If I can't fix it, it's not broke!
You also have to make sure your circuit is provisioned with ANI/CLID. If it is, I'm pretty sure the lec is expecting to see all 10 digits for an outpulse, if it does not see all ten, the ANI will use the default (main billing number on your circuit)
- Status
Similar threads
- Locked
- Question
- Locked
- Question
