thread798-1637211
I have an OP81C running Succession 5.0 and a Cisco Call Manager Cluster (8.6.2) in a CDP configuration. The PBX has the PSTN connectivity and all Cisco phones are DSC's in the PBX. I recently had to change the T1's configuration between the PBX and the Voice Gateways from QSIG to S100 because the Routes need to support MLPP. Therefore I had to change the Route and Trunk members to type "ATVN" instead of "TIE". Since then, for all calls made through the Auto Attendant (Call Pilot) to an IP Phone, I only see the Call Pilot DN that forwarded the call to the IP Phone extension. If the call is made to a DID, the CLID travels. Prior to these recent changes, the CLID was travelling ok. From what I have read on other forums, the CLID will only pass if I use QSIG???
Any suggestions anyone?
Thanks.
I have an OP81C running Succession 5.0 and a Cisco Call Manager Cluster (8.6.2) in a CDP configuration. The PBX has the PSTN connectivity and all Cisco phones are DSC's in the PBX. I recently had to change the T1's configuration between the PBX and the Voice Gateways from QSIG to S100 because the Routes need to support MLPP. Therefore I had to change the Route and Trunk members to type "ATVN" instead of "TIE". Since then, for all calls made through the Auto Attendant (Call Pilot) to an IP Phone, I only see the Call Pilot DN that forwarded the call to the IP Phone extension. If the call is made to a DID, the CLID travels. Prior to these recent changes, the CLID was travelling ok. From what I have read on other forums, the CLID will only pass if I use QSIG???
Any suggestions anyone?
Thanks.
