We've just installed MM5.2, everything works fine. However when voicemails are received in outlook where the CLI was presented it shows the number but strips off the leading zero.
e.g 01234 567890 shows as 1234567890.
Not a major issue but users with iphone / palm pre's etc want to just highlight the calling number to call them back etc. The public net provider dosent send 0 as you know, we have to insert it on the "ch sys feat" but this is only a setting for inserting the 0 for the phone handset display. On the same page I've tried setting "send cpn to ASAI" to yes but no change.
I've played about where I can but can't re-add the leading zero - any ideas?
e.g 01234 567890 shows as 1234567890.
Not a major issue but users with iphone / palm pre's etc want to just highlight the calling number to call them back etc. The public net provider dosent send 0 as you know, we have to insert it on the "ch sys feat" but this is only a setting for inserting the 0 for the phone handset display. On the same page I've tried setting "send cpn to ASAI" to yes but no change.
I've played about where I can but can't re-add the leading zero - any ideas?