CLDFI......NO RESOURCE

[aprasha]

Part of my IODDP:
IODDP;
I/O DEVICE DATA
NODE IODEV/SUBFS BPOS/EQU SIPOS TYPE/USAGE STATUS AUTH
NIU NET 001-1-70-4 - NETWORK/OUT IN SERVICE
NIU TELNET1 001-1-70-4 - NETWORK/MML - 7

I can connect perfectly through my ethernet. The NIU works fine....but....I need it to use it for CIL through Ethernet.

I do my IONCI and no problem. Verified with IONCP;

But the problem is with CLDFI :

CLDFI:FILE=TARIF1,IODEV=NET,USER=CIL-1;
NOT ACCEPTED
NO RESOURCE

I've executed this command in other 5 MDs (all in BC10), and no problem with any except this one...

Tryed USER=CIL-2 (with IONCI first) and a different file name, but no resource again. Erased all with IONCE and restarted again with no results.

Other commands:
----------------------------------------------
CLDFP;
FILE ADMINISTRATION DATA
FILE STATE IODEV USER DEVICE STATE PRIORITY
END
----------------------------------------------

Any idea?

Thx all!!

 

[jazaya]

your iodev=net at NIU NET 001-1-70-4 - NETWORK/OUT IN
that is why.

Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com

 

[doktor]

If you have a MD110 in BC10 with a low CNA, then there could be a problem with the USER parameter.
You should then set the USER to NONE, and it will work.
Best regards from the doktor

 

[aprasha]

for jazaya:
I use IODEV=NET in the other 5 MDs, and no problem with them, but I changed to IODEV=APRA. Tryed again, but NO RESOURCE.

for doktor:
I use USER=NONE in IONCI => USER DOES NOT EXISTS
In CLDFI => USER NOT ASSIGNED

Any other idea??

Thx !!!!

 

[doktor]

Do you have any CIL license?
Remember that there exists 2 types of CIL licenses.
CIL for LAN/Ethernet and CIL for V24.
Check with LIDAP;
Best regards from doktor

 

[aprasha]

That was a good idea, but all license are allowed and none is full (the licenses with 1 allowed are 0 used, the others with 65535 allowed, of course, neither are full). Even, I've compared the LIDAP of this MD with one on other MD that works ok and the column ALLOWED is the same.

There must be anything. Perhaps, I need to create a directory or else? (I don't know anything about MD's system file).

Thx for answering!

 

[aprasha]

RESOLVED!!
As I thought, it was a software problem, fixed by Ericsson with new revision of the programs CLHH and CLOM (I know this thanks to DUSYI printout).

By the way, another problem was that DMPSIZ in CLOHI was 2 as maximun value, meanwhile the others MDs admit 3. (I tell this for someone that could have the same problem in the future).

I'm a happy man

Thx all for answering and been there!!