Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ClassView problem after adding a macro to the VC98 IDE

Status
Not open for further replies.

C4C

Technical User
Jan 1, 2003
11
US
Hello,

I'm an accomplished VB6 programmer, but that's the extent of my programming knowledge. Visual Basic has satisfied my needs but I decided it was time to learn the C/C++ programming languages.

I find the VC98 IDE to be by far more user friendly in commparison to the VB98 IDE with the exception that it lacks some very common features. The ability to comment & uncomment selected lines of code is the first issue that I have tried to address.

The macro is quite simple and functions as one would expect it to. All is well when I close the VC98 IDE, but the next time that I open it I'm confronted with a MsgBox that states: Cannot access the ClassView information file.

At this time the only way that I have found to correct the problem is to remove the macro and start a new work space for my project. Hopefully this post will be viewed by some one that can advise me of how to overcome this issue.

Servo Wizard
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top