Class of Sets

[MorpheusWin2K]

Is there a way to print out a list of sets that have a given feature, ie "CFXD or CFXA" in an Option 11C?

Thank You

 

[jimeec]

Yes,I don't know what release this was available but you can go into LD 81 and at req you type LST,cust=0,enter down to feat for "feature",enter in the prompt you want.In your case cfxa or cfxd and it will give you a list of TN's with the sets that have this feature.Unfortunatly it does not provide the DN of the phone so you will have to print the page and then perform a TNB in LD 20 on each one to aquire the DN's.You can also do a count of sets with a specific feature as well by entering CNT at REQ prompt.Hope this helps.

 

[MorpheusWin2K]

Thank You that tip did help, plus the "CNT" feature is nice. I was really hoping to get a list of DN's that had the feature. More importantly I'm trying to print out a list of DN's that the Controlled Class of Service has been turned on, allowing that phone to make calls. It should show up as "CCSA-CSI" if they can't make calls and "CCSA-CSA" if they can make calls.

Are you familar with how to achive this?

Thanks

 

[jimeec]

As far as I know with that feature it is either ccsa or ccsd for allowed and denied.When it is set for ccsa in cls it and you print the tnb after it shows as ccsa-csi-which should mean you can place calls from the set and when set for ccsd it shows up in the tnb as ccsd which means you can't place calls.I have never seen ccsa-csa but we do not use that feature to restrict and unrestrict.We use the ncos prompt.

 

[jimeec]

I would just list the ccsa prompt in LD 81.