Clarion from WIN-98 to WIN-NT

[pavithra123]

I have developed a banking software to emboss cards which has interfaces to other hardwares like pin pad device , embossing machine and a Micro computer as well.
The protocol used is TCP/IP. The program is written and complied in WIN-98 and it works well on WIN-98 OS but when i transport the EXE to WIN-NT Server / Workstation i can open the application do restricted tasks but if the tasks involves interaction with the Micro-computer, The OS generates a Dr.watson error.

The suspcions are the EXE while communicating does not support the 32 bit application or the TCP/IP used does not support 32 bit application.

Please do give valid reasons for this.

 

[Gaudalier]

Have You Checked The Compatibity of the hardware devices with MS NT???

Like You've already know, NT Don't allow any device to "direct access" to hardware's resources!

-----
carabez@hotmail.com

 

[pavithra123]

Thanks for the reply before i start investigating the NT compatible hardware resources i made a small test i removed the interface link with the NT system and tried again even then t got the same result.

Can you please help me out of this.

when the interface is not present normally the application i have developed would have timed out.

Do advise about the necessary action to be taken to run it successfully in WIN-NT.