Hello. I need to change the extension number of the Ethernet data module in my G3si, since it is in the wrong extension range. Can I just remove it and re-add it with the same port but different extension number? Are there any other screens/pages that will need to be changed? Also, I do not have maintenance command access on this system, so I can not busy/release or test, is it necessary to busy anything out before changing this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CLAN/Data module question. 1
- Thread starter Phonetech
- Start date
-
1
- #2
You may have to disable in the ip-interface screen, the CLAN card. Then remove and re-add the data module. Then re-enable the ip-interface.
Print the "display ethernet" options screen first as well incase it changes after you do all that.
Netcon1
Print the "display ethernet" options screen first as well incase it changes after you do all that.
Netcon1
- Status