Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cisco WS2958G L2 switch...purchased with deleted CatOS, unable to communicate with Rommon mode

Status
Not open for further replies.

Bledi

Technical User
Oct 3, 2013
1
AL
I've purchased five WS2958G L2 Cisco switches from ebay. The seller had ereased the CatOS and the switches boot to Rommon mode.
I've tried to educate myself as to how to upgrade them but it seems that i'm stuck at this point.
I can see printout on hyper terminal but I'm unable to communicate with the rommon menu. If i change the setting to print local echo on hyperterminal, then i can type the commands but, after sending them there is no response from the switch.
This is the screen i get from the WS2958G:

0:00.577172: Please set IPAddr variable
0:00.577753: Please set Netmask variable
0:00.578109: Please set Broadcast variable
0:00.578474: No gateway has been specified
0:00.578968: Network is not configured
WS-X2948G bootrom version 6.1(4), built on 2001.07.30 14:43:26
H/W Revisions: Fin: 2 Head: 11 Board: 1
Supervisor MAC addresses: 00:50:54:4a:84:00 through 00:50:54:4a:87:ff (1024 addresses)
Installed memory: 64 MB
Testing LEDs.... done!
rommon 1 >

Am I missing something here? Is there a specific key combination to send first....or perhaps i need some kind of elevated privilege?
I would really appreciate any help at this point.
I've tried several terminals so far, changed settings to Cisco specs on serial connection. I'm using an original Cisco serial DB9 (female) to RJ45 cable.
The serial DB9 female side is on serial port on PC and the RJ45 is connected to the Console port of the switch.

looking forward to learn something...
thanks


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top