Cisco Wireless Bridge

[JMay0816]

Not sure if this is the correct forum for this question (please redirect me if it is).

I am looking to connect a remote location to our main LAN via a wireless bridge (Cisco 1310). I was going to use a WAP (Cisco 1100) at the facility end but someone told me that a bridge can only communicate with another bridge.

Is this true?

thx

 

[Minue]

Hello
I have more or less the same setup with older equipment.The bride will act like a wireless client.Just give it the same SSID as the AP1100,put it in the same subnet,configure your security and you are good to go.
Regards